For the majority of ACS observations, target acquisition is simply a matter of
defining the appropriate aperture for the observation. Once the telescope acquires its guide stars, your target will be positioned within ~1 to 2 arcseconds of the specified aperture. For observations with the ramp filters, one must specify the desired central wavelength for the observation.
ACS is expected to be used primarily for deep, wide-field survey imaging.
Important issues for observers to consider will be the “packaging” of their observations, how observations are CR-SPLIT
to mitigate the impact of cosmic rays, how sub-stepping or “dithering” of images for removal of hot pixels is implemented, and how, if necessary, to construct a mosaic pattern to map the target. Narrowband observations with the WFC are more likely to be read noise limited, requiring consideration of optimum number of readouts
. Observations with the MAMA detectors are not affected by cosmic rays or read noise, but long integration times will often be needed to obtain sufficient signal-to-noise.
A typical ACS observing sequence consists of a series of 10 to 20
minute dithered exposures for each desired filter. Observers will generally not take their own calibration exposures. See Chapter 7
for more details about observing strategies.
At the conclusion of each exposure, the science data are read out from the detector
and placed in ACS’s internal buffer memory, where it is stored until it can be transferred to the HST
solid state data recorder (and thereafter to the ground). The internal buffer memory is large enough to hold one WFC image, or sixteen SBC images, and so the buffer typically must be dumped before or during the following WFC exposure. If the following exposure is longer than ~339 seconds, then the buffer dump from the preceding exposure will be performed during integration (see Section 8.2
for a more complete discussion).
ACS’s internal buffer stores the data in a 16
bit-per-pixel format. This structure imposes a maximum of 65,535 counts per pixel. For the MAMA detectors this maximum is equivalent to a limit on the total number of detected photons per pixel which can be accumulated in a single exposure. For the WFC, the 16 bit buffer format (and not the full well) limits the photons per pixel that can be accumulated without saturating in a single exposure when GAIN=0.5 or GAIN=1.0 are selected. This is not an issue when the default GAIN=2.0 is used. See Chapter 4
and Chapter 7
for a detailed description of ACS instrument operations.