Phase 2
ETCs
Performance
Phase 1
- Can I extend the proprietary period for my data? Answer
- What overhead is required to change ACS detectors during an observing sequence? Answer
- Are autoparallel observations allowed for ACS and what is their policy? Answer
- Are there special policies for the use of SBC and parallel observations? Answer
- Is there any target acquisition mode available? Answer
- Are digital versions of the transmission curves available? Answer
Phase 2
- How accurate are the ACS aperture overlays in the VTT? Answer
- What are ACS subarrays? How can I use them? Answer
- What guiding concerns should I have for my ACS observations? Answer
- Why do I get serial buffer dumps in RPS2 and why does it take so long to process? Answer
- How do POS-TARGs and patterns interact? Answer
- Why does adding a WFPC2 coordinated parallel to an existing ACS/WFC result in large changes? Answer
- Will a 9-degree moon avoidance angle gaurantee a zodi-limited background level? Answer
- Is it OK to put a bright star in the gap between the two WFC chips? Answer
- How well do integral pixel dithers in the WFC work? Answer
- What is the offset in the U2 direction that can be taken before a gap appears? Answer
- What aperture should I use for large mosaics? Answer
- Can I add WFPC2 coordinated parallels to my ACS observations? Answer
- What are the current ACS/WFC aperture parameters? Answer
- Dithering for hot pixels Answer
- What are the minimum and maximum length of an exposure with each detector? Answer
- How do I change the configuration from my Phase I submission? Answer
ETCs
- What is the meaning of the 2x2 resolution element in the ACS ETC for an extended source?
What do I do if my source is larger than the 2x2 element?
Answer
- Are digital versions of the transmission curves available? Answer
- What do "counts" mean in the ACS Instrument Handbook? Answer
- What are N_pix, epsilon_f and epsilon_f(1)? Answer
- What is (epsilon_Nspix)' and how is the spectroscopic S/N calculated? Answer
- How can I maximize SNR when observing a faint diffuse target in the UV with the SBC? Answer
- How do I use the ETC for an emission-line source? Answer
- Will binning be available for the CCDs? Answer
Performance
- What are the maximum allowable SBC count rates? Answer
- What type of compression is available in ACS? Answer
- I just got my ACS data. What are all these files? Answer
- What technique will be used to determine the geometric distortion? Answer
- How bad is the fringing at wavelengths longer than 7500A? Answer
- What strategies can I employ to increase my signal-to-noise? Answer