Cosmic Origins Spectrograph Instrument Handbook for Cycle 17

3.1 The Location of COS in the HST Focal Plane

---

COS will be installed in one of the axial instrument bays near the rear of HST. It will replace COSTAR, which was installed in the first servicing mission, in 1993, to provide correcting optics for the other axial instruments that were in HST at the time (FOC, FOS, and GHRS).

The location of the COS aperture in the HST focal plane is shown in Figure 3.1. Note the relative orientation of the HST V₂ and V₃ axes (the V₁ axis is along HST's optical axis), as well as the relative locations and orientations of the other instruments. Note that the COS aperture is 325 arcsec from the V₁ axis, and that COS is located in the +V₂, -V₃ quadrant. Also note that the direction along the dispersion of a COS spectrum corresponds to motion equally in V₂ and V₃ in a direction along a radius of the HST field of view. Specifically, increasing wavelength is in the direction of +V₂ and -V₃ for both the FUV and NUV (see Figure 3.2). Full information on the locations of all HST's instruments may be found at:

 http://www.stsci.edu/hst/observatory/apertures/siaf.html

Figure 3.1: A Schematic View of the HST Focal Plane.


 
This drawing shows the entire HST focal plane and the apertures of the scientific instruments as it will appear after SM4. Note that this view is from the rear of the telescope looking forward toward the sky, the opposite of the sense of Figure 3.2.
 
Figure 3.2: Schematic Layout of the COS Detectors.


 
This view is from the front of the telescope looking aft, with the V₁ axis being at the bottom tip of the square. The dashed arrows show the direction of increasing wavelength for the two detectors, and "XD" shows the increasing wavelength for the NUV cross-dispersion direction. For both the FUV and NUV, increasing wavelength is in the (+V₂, -V₃) direction. Note that this diagram is purely schematic and it is intended to show relative directions. This diagram does not show the locations of apertures. As seen in Figure 3.1, the bottom corner of this square (at V₁) is where the WFC3 camera is located.